Topic: Nitrous Kit for my CB

[Sam Green Racing]

Am I good at guessing or what

Sam.

Sam,

You are good at everything... that is what we hear on this side of the pond.

I can't wait to see your dyno figures on Chris's bike.  Next week right?

Art

I'm thinking around the 80 mark Art.  Dyno on the 22nd.

Sam.

[sparty]

Am I good at guessing or what

Sam.

Sam,

You are good at everything... that is what we hear on this side of the pond.

I can't wait to see your dyno figures on Chris's bike.  Next week right?

Art

I'm thinking around the 80 mark Art.  Dyno on the 22nd.

Sam.

You may be in for a shock.  It may be in the upper 80s.

[Sam Green Racing]

We're not to worried what it makes Art, we're more intrested in where it makes it.

I told Chris to change up at 9000rpm but a few times he's missed it and says that from just over 9100rpm it spins to 10500rpm before he can catch it.
I said it might be a bit of clutch slip but he says he can feel it go quicker when it gets up there, it may have a bit of a power band up top.
We'll find out next week

Sam.

[old750]

Wow looks good! Are those gasket surfaces sandblasted?

The rear wheel HP with the NOS will be in the neighborhood of 150 RWHP with the 60 shot of NOS.  The RWHP without NOS should be around the low 90s.

Check out my build page: http://www.basd.net/staff/aentz/CB750/CB750_page.htm

[sparty]

Wow looks good! Are those gasket surfaces sandblasted?

The rear wheel HP with the NOS will be in the neighborhood of 150 RWHP with the 60 shot of NOS.  The RWHP without NOS should be around the low 90s.

Check out my build page: http://www.basd.net/staff/aentz/CB750/CB750_page.htm

They are glass bead blasted.